← menudiving.wtf

Korg

Minilogue XD

💾 Firmware 2.10

📖 Official Manual

Features

Invert LFO Waveform

  1. Hold down Shift, turn Int.

LFO Syncing

  1. Enter Program Edit Mode, then tap 7

  2. Key sync resets the LFO on each note

  3. Voice sync keeps all four voices of polyphony on the same cycle

LFO Target

  1. Enter Program Edit Mode, then tap 7

  2. Choose the target of the LFO's modulation

    Value Target
    All All three oscillators
    VCO1+2 The two analog oscillators
    VCO2 Only VCO 2
    Multi Only the multi-engine

Motion Sequencing - Param Lock

  1. Hold down one or more of the 1–16 buttons

  2. Move a knobs or manipulate a switches. This will set the value for the steps you held down

  3. Smoothing can be configured in Sequence Edit Mode, button 12

Motion Sequencing - Real Time

  1. Press Play

  2. Press Motion Mode

  3. Press Rec

  4. Move knobs or switches. Up to four different things can be recorded

  5. Smoothing can be configured in Sequence Edit Mode, button 12

Noise Engine

  1. Set the multi-engine switch to the bottom setting

  2. Adjust the Type knob to choose the type of noise:

    Type Behavior
    High Noise with a high-pass filter via Shape
    Low Noise with a low-pass filter via Shape
    Peak Noise with a bandpass filter via Shape
    Decim Sample-rate reduced noise with Shape adjusting rate and Shift Shape adjusting keyboard tracking

Oscillator Sync

  1. Set Sync to on

  2. Make sure VCO 2 is set to a higher pitch/octave than VCO 1

Sub-types for Modulation Effects

  1. Select a modulation effect with the Select switch

  2. Hold down Shift, use Select to rotate sub-types.

Time Division

  1. Enter Sequence Edit Mode, then tap 7

  2. Step Resolution can be used to adjust how long each step is

VPM WTF

  1. This is basically FM so gl lol

  2. The Type sets the carrier (what you hear) and the modulator

    Value WTF
    Sin1 Sine with a Sine modulator
    Sin2 Sine with self-modulation
    Sin3 Sine with 3x Harmonics
    Sin4 Sine with 5x Harmonics
    Saw1 Saw with basic carrier?
    Saw2 Saw simulated with Sine
    Squ1 Square carrier
    Squ2 Square simulated with Sine
    Fat1 1/4 subharmonic, self feedback, drive
    Fat2 3/4 subharmonic, self feedback, drive
    Air1 Noise-modulated sine
    Air2 Sine modulated by noise and sine
    Decay1 Decaying modulation
    Decay2 Strong decaying modulation
    Creep Weird
    Throat Weird

  3. Shape sets the intensity of the modulation

  4. Shift + Shape adjusts modulator ratio and adds overtones

  5. More control is available in the program edit menu

Wet/Dry Balance for Effects

  1. Select the effect with the Mod/Rev/Del switch

  2. Hold down Shift, and turn Depth to adjust wet/dry.

MIDI Info & CCs

✅ Responds to Program Change

Param CC #
Filter Cutoff 43
Filter Resonance 44
Mod Time 28
Mod Depth 29
Reverb Time 108
Reverb Depth 109
Delay Time 105
Delay Depth 106
LFO Intesity 26
LFO Rate 24
VCO1 Shape 36
VCO2 Shape 37
Multi-Engine Shape 54